Multi-tech-systems MTS2SA-T Manual de usuario descargar pdf (Pagina 82)

Chapter 9 – Modem (Transparent) Mode

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 82

Scenario 1 – MultiConnect IP as a Modem

In this scenario, once the physical link is up on the built-in modem interface; i.e., by dialing or answering,

the serial device connected to the RS-232 interface (S0 of the target) can communicate to the device on

the built-in modem interface (S1 of the target) and vice-versa.

MultiConnect IP as a Modem

Commands for MultiConnect IP as a Modem

# set operation-mode modem

# set serial s0 escape-monitor enable

# set serial s0 escape-string "+++inets0"

# set serial s0 stop-bits 1

# set serial s0 baud-rate 115200

# set serial s0 data-bits 8

# set serial s0 parity none

# set serial s0 flow-control rts-cts

# set serial s1 stop-bits 1

# set serial s1 baud-rate 115200

# set serial s1 data-bits 8

# set serial s1 parity none

# set serial s1 flow-control rts-cts

# save

Notes:

• You can switch from Data mode to Command mode using the escape-monitor-string

configuration. The control is transferred to the command prompt. Either “Login” or the

command shell is prompted depending on the configuration.

• You can switch from Command mode to Data mode using the restore session command.

• The data session is dropped if the physical link goes down.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 180 181

Sin comentarios

Multi-tech-systems MTS2SA-T Manual de usuario Pagina 82