Multi-tech-systems MTS2SA-T Manual de usuario descargar pdf (Pagina 76)

Chapter 8 – Auto Dial-in Feature

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 76

Scenario 2 – Serial Auto Dial-in in Telnet Mode

This example shows how to setup a serial auto dial-in session in Telnet mode. The auto dial-in session is

opened by Telnet client embedded in the MultiConnect IP to the configured server on a configured port.

Once the session is opened successfully, there can be two-way traffic between the serial device and the

remote server.

• You can switch from Command Prompt to Dial-in session using the restore session command.

• You can switch from Dial-in session to Command Prompt using <escape-monitor-string>.

Prerequisites

• RAW mode (Global and each port) MUST BE DISABLED using the following command:

Enable/Disable the RAW mode globally for all Auto-Dial-in sessions:

# set ip telnet raw-mode <enable/disable>

Auto Dial-in Feature in Telnet Mode

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 180 181

Sin comentarios

Multi-tech-systems MTS2SA-T Manual de usuario Pagina 76