Multi-tech-systems MTS2SA-T Manual de usuario descargar pdf (Pagina 152)

Chapter 13 – SMTP Client

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 152

Scenario 8 – Sending a Mime Encoded Binary

Email with Attachment Using Interactive

Mode

Issue the following command: send-mail -b

The SMTP session then enters into interactive mode requesting the to-address, the cc-address,

subject, and message body to be entered. After completion of the message, type Ctrl+D to end the

message.

The SMTP session in interactive mode requests media-type, media-subtype, filename, filesize, and the

attachment body as shown in the figure.

When the attachment body reaches the filesize, another message is displayed asking whether to continue

with one more attachment. Type n for No. The email with its attachment is sent only to the entered to-

addresses (if any) and cc-addresses (if any). The subject and message body are used as entered in

the interactive mode.

Notes:

1. The email is sent only to addresses entered in interactive mode.

2. If the subject is pre-configured using set commands, it will be used as the subject for the email.

3. Type Ctrl+C to quit the email at any given time.

4. If the host wants to quit the email while sending the binary attachment body, type Ctrl+C and wait

for 3 seconds without entering any character to quit the email.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 180 181

Sin comentarios

Multi-tech-systems MTS2SA-T Manual de usuario Pagina 152