Multi-Tech Systems MTASR3-200 Manual de usuario descargar pdf (Pagina 21)

Chapter 3 - Software Loading and Configuration

MTASR3-200

6. The MultiRouter Setup Installation dialog box appears which states, "Please select a communication

port for the setup utility to use." In other words, select which COM port on your PC is connected to

the Command Port of the RASFinder.

Select the COM port (COM1,COM2,COM3, or COM4) for the setup utility. The default port is COM1.

Click on OK when you are satisfied with your selection.

7. When the software is successful loaded on your PC, a system message is displayed stating

"MultiRouter Installation Successful. Do you want to setup default parameters?"

8. Ensure that the Fail LED is off before you click on the Yes button. Click on Yes to set up the default

parameters. If you click on No, the installation is complete.

9. To configure your RASFinder, a series of default dialog boxes, MultiRouter - Novell IPX Protocol

Default Setup, MultiRouter - IP Protocol Default Setup, MultiRouter - WAN Port Default Setup will be

displayed.

If your network protocol is IPX, continue with the following steps. If your network protocol is IP, click

on the IPX Routing Enable check box to disable IPX, then click on the OK button and proceed to

step 14.

10. Router Name: You can either use the default Router Name or assign a new Router Name in this

field. If you assign a new Router Name, it must be a printable ASCII string of a maximum of 47

characters. The router name is used by the RASFinder to advertise its service in the IPX inter-

network.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 81 82

Sin comentarios

Multi-Tech Systems MTASR3-200 Manual de usuario Pagina 21