Multi-tech-systems MVP210-SS Manual de usuario descargar pdf (Pagina 144)

Technical Configuration MultiVOIP User Guide

144

E&M Interface Parameter Definitions

Field Name Values Description

Interface E&M enables E&M functionality

Type Types 1-5. Refers to the type of E&M

interface being used.

Mode 2-wire or 4-wire Each E&M interface type can be

either 2-wire or 4-wire audio.

Signal Dial Tone or

Wink

When Dial Tone is selected, no

wink is required on the E lead

or M lead in the call initiation or

setup.

When Wink is selected, a wink

is required during call setup.

Wink Timer

(in ms)

integer values,

in milliseconds

This is the length of the wink

for wink signaling.

Applicable only when Signal

parameter is set to “Wink.”

No Response

Timer

integer values (in

seconds)

The value here denotes the time

(in seconds) after which the call

attempt would be disconnected

by the FXO Interface because

there was no answer.

Disconnect on

Call Progress

Tone

Y/N

Allows call on FXO port to be

disconnected when a PBX issues a

call-progress tone denoting that

the phone station on the PBX that

has been involved in the call has

been hung up.

Pass Through

Enable

Y/N When enabled (“Y”), this

feature is used to create an open

audio path for 2- or 4-wire. The

E&M leads are passed through

the voip transparently.

Applicable only for E&M

Signaling with Dial Tone (not

applicable for Wink signaling).

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 414 415

Comentarios a estos manuales

Sin comentarios