Multi-tech-systems ISIHP-2U Manual de usuario descargar pdf (Pagina 116)

116 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD

Terminal Adapter AT Commands & S-Registers

Sets the value of an S-register, where r is the number of the S-register, and n

is the value you want to set.

Sr? Read S-Register

Values: r = 05 (S1 is read only) , 7, 8, 10, 25, 32, 34,

50, 52-57, 75-77, 80; n varies

Default: None

Reads the value of an S-register, where r is the number of the S-register.

Vn Terse/Verbose Result Codes

Values: n = 0 or 1

Default: V1 (Verbose)

Controls whether the TAs result codes display as digits (terse) or as words

(verbose). (Use the Q command to enable or disable the display of result

codes.)

V0 Enable terse result codes.

V1 Enable verbose result codes.

Xn Connect Messages

Values: n = 0-5

Default: X2 (Enable all messages) and

(Disable printing CLI with CONNECT message)

Selects the result code messages that the TA sends to the computer.

X0 Enables messages OK, CONNECT, RING,

NO CARRIER, and ERROR (terse result

codes 04).

X1 Enables all messages except BUSY (terse

result codes 05, 1014, 1719, 28, and

32). If a call is placed to a busy line, NO

CARRIER displays.

X2 Enables all messages (terse result codes 0

5, 7, 1014, 1719, 28, and 32).

X4 Disables printing Calling Line Identification

(CLI) at the end of the CONNECT message

line. This command does not affect X0, X1,

nor X2.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 154 155

Sin comentarios

Multi-tech-systems ISIHP-2U Manual de usuario Pagina 116