Multi-tech-systems MVP400 Manual de usuario descargar pdf (Pagina 10)

MultiVOIP Quick Start Guide

5. If you are connecting a station device (analog telephone,

fax machine, or Key Telephone System (KTS)) to your

MultiVOIP, connect one end of an RJ11 phone cord to the

Voice/Fax Channel 1 FXS connector on the back of the

MultiVOIP and the other end to the station device.

If you are connecting a PBX extension to your MultiVOIP,

connect one end of an RJ11 phone cord to the Voice/Fax

Channel 1 FXO connector on the back of the MultiVOIP

and the other end to the PBX extension.

If you are connecting an E&M trunk from a telephone

switch to your MultiVOIP, connect one end of an RJ45

phone cord to the Voice/Fax Channel 1 E&M connector

on the back of the MultiVOIP and the other end to the

trunk. Refer to the User Guide for E&M pin assignments.

If you are connecting to an E&M trunk, you need to ensure

that the E&M trunk jumper is in the correct position for the

E&M type trunk. The default E&M jumper position is E&M

type 2. To change the E&M jumper position, perform the

E&M jumper block positioning procedure in the following

section.

6. Repeat the above step to connect the remaining telephone

equipment to each Voice/Fax Channel on your MultiVOIP.

7. Turn on power to the MultiVOIP by placing the ON/OFF

switch on the back panel to the ON position. Wait for the

BTG LED on the MultiVOIP to go OFF before proceeding.

This may take a couple minutes.

If you need to change the E&M Jumper Block positioning, refer

to the following section. Otherwise, proceed to the Installing

the Software section to load the MultiVOIP software.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Sin comentarios

Multi-tech-systems MVP400 Manual de usuario Pagina 10