Multi-tech-systems Multi-Tech FaxFinder FF420 Manual de usuario descargar pdf (Pagina 8)

FaxFinder Cabling Guide

3. Connect FaxFinder to Ethernet Network.

Caution: Before connecting to the Ethernet Network, make sure that the

network to which you are connecting the FaxFinder is not a

192.168.2.x subnet, else the FaxFinder’s factory default IP address of

192.168.2.1 will cause data interference.

If it is a 192.168.2.x subnet, connect from the Administrative PC

to the FaxFinder using an RJ45 crossover cable until the

FaxFinder’s IP address has been configured. Thereafter,

connect the FaxFinder into the network with an ordinary RJ45

cable.

4. Connect to Telephony Service

The FaxFinder’s fax modems can either be connected to a PBX

(for use in Automated Routing Mode) or to a POTS line

(for use in Manual Routing Mode).

Automated Routing Mode Manual Routing Mode

Plug one end of the phone

cable into the FaxFinder’s

LINE jack and the other into

an available Station Port on

the PBX.

Plug one end of the phone

cable into the FaxFinder’s

LINE jack and the other end

into your standard telephone

receptacle.

82100262L

1 2 3 4 5 6 7 8

Sin comentarios

Multi-tech-systems Multi-Tech FaxFinder FF420 Manual de usuario Pagina 8