Multi-tech-systems MT4X56USB Manual de usuario descargar pdf (Pagina 21)

Chapter 3 - Software Loading and Configuration

MT4X56USB 21

MT4X56USB Drivers for Windows NT 4.0

Because NT 4.0 does not support USB, Multi-Tech provides a USB stack that will be installed along

with the necessary drivers. To do this, you must have have NT Service Pack 3.00 or higher and an

account that has administrative privileges.

Note: “Plug-and-Play” operations are not supported in an NT 4.0 (or earlier) operating system.

1. Ensure that power to the MT4X56USB is on but that the USB cable remains disconnected.

2. Insert the MT4X56USB Disk 2 into drive A.

3. Click Start | Run.

4. Type A:\setup and click OK.

5. The install program prompts you to make certain you have NT Service Pack 3.00 or higher. Click

Yes to continue.

6. The MultiModemUSB Drivers Install dialog box displays.

Click Next >.

7. The Read Multi-Tech Software License agreement screen is displayed. Read carefully. If you

accept the terms of the agreement, click Yes.

8. The Release Notes screen is displayed (Release Notes can also be found after installation in the

Start menu under Programs | Multi-Tech USB Utilities).

Click Next >.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 95 96

Sin comentarios

Multi-tech-systems MT4X56USB Manual de usuario Pagina 21