Multi-tech-systems MT3334HD8 Manual de usuario descargar pdf (Pagina 33)

3 AT Commands

CommPlete Communications Server 27

&P1 sets a pulse dial ratio of 67 ms break to 33 ms make.

&RDn Square Wave Ring Detect

= 0 or 1

Default: &RD0 (U.K. and International models)

&RD1 (North American models)

The ring back sound that you hear when you dial a number is generated at the local telephone office or

PBX. Normally, it is a sine wave analog tone. However, some PBXs generate square wave rings that can go

undetected by normal ring detection circuits, resulting in a failure to make a connection. To enable your

modem to detect square wave rings, use the &RD1 command.

&RD0 enables sine wave ring detection only.

&RD1 enables sine wave and square wave ring detection.

$Tn Calling Tone

= 0 or 1

Default: $T1

The $T command enables or disables the modem’s calling tone, which is required by some European

countries to identify the caller as a modem.

$T0 enables the calling tone.

$T1 disables the calling tone.

#Tn Trellis-Coded Modulation

= 0 or 1

Default: #T1

The #T command enables or disables trellis-coded modulation (TCM) on the modem. There is usually no

need to disable TCM, except for an unusual line condition called impulse noise.

#T0 disables TCM.

#T1 enables TCM.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

Sin comentarios

Multi-tech-systems MT3334HD8 Manual de usuario Pagina 33