Multi-tech-systems MT5600ZDX Manual de usuario descargar pdf (Pagina 52)

Model MT5600ZDX

Bits 0-4 Desired line connection speed. If an invalid number is entered, the

number is accepted into the register, but S37 will act as if the default value

has been entered.

0 = Attempt automode connection. If N0 is active, connection is attempted

at the most recently sensed DTE speed (+MS command settings are updated

to the most appropriate values). If N1 is active, connection is attempted

at the highest possible speed (+MS settings are updated to 11,1,300,2880

to reflect V.34, automode, 300 bps minimum speed, and 28800 bps

maximum speed)--Default.

S38 decimal 0255 20 This register specifies the delay

between the modems receipt of

the H command to disconnect (or

ON-to-OFF transition of DTR if

the modem is programmed to

follow the signal), and the dis-

connect operation. Applicable to

error-correction connection only.

If S38 is set to a value between 0

and 254, the waits for the remote

modem to acknowledge all data

in the modem buffer before dis-

connecting. If S38 is set to 255,

the modem does not time-out

and continues to attempt to de-

liver data in the buffer until the

connection is lost or the data is

delivered.

S39 Flow Control Bit-Mapped Options Status (Indicates the status

of command Options.) Default: 3

Bit 0-2 Status of Command Options

0 = No Flow Control

3= RTS/CTS (&K3)--Default

4 = XON/OFF (&K4)

5 = Transparent XON (&K5)

6 = Both Methods (&K6)

Bit 3-7 Reserved

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 83 84

Sin comentarios

Multi-tech-systems MT5600ZDX Manual de usuario Pagina 52