Multi-tech-systems MULTIVOIP MVP210/410/810 Manual de usuario descargar pdf (Pagina 126)

Chapter 6: Using the Software

Multi-Tech Systems, Inc. 126

Upgrading Software

As noted earlier the Upgrade Software command transfers, from the controller PC to the MultiVOIP unit, firmware

(including the H.323 stack) and settings. The settings can be either Factory Default Settings or Current

Configuration Settings.

Figure 6-33: Upgrade software path

NOTE: To upgrade a MultiVOIP from software version 6.04 or earlier, an ftp primer file must first be sent to

the VOIP. This file is located in the Software/ftp_Primer folder on the CD and the file name is

"FTP_Primer.bin". Before uploading this file, it must be renamed "mvpt1ftp.bin". The VOIP will only

accept files of this name. This is a safety precaution to prevent the wrong files from being uploaded to

the VOIP. Once the primer file has been uploaded, upload the FTP firmware file. If you accepted the

defaults during the software loading process, this file is located on your local drive at C:\Program

Files\Multi-Tech Systems\MultiVOIP X.NN where the X is the software number and the .NN is the

version number of the MultiVOIP software on your local drive. Of course the firmware file is named

‘mvpt1ftp.bin’.

Important: You cannot go back to 6.04 or earlier versions using FTP. You must use ‘upgrade software’ via

the serial port.

Important: These ftp upgrade instructions do not apply to software release 6.05 and above.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 143 144

Sin comentarios

Multi-tech-systems MULTIVOIP MVP210/410/810 Manual de usuario Pagina 126